23May2011
911 SC
Just finished up a little of this and a little of that on a 911 patient. We replaced the oil sump plate gaskets and installed a new turn signal/dimmer switch which was malfunctioning and flashing the brights when using the turn signals. Common issue. The patient. We have a few transaxle leaks from the nose seal and such, but decided to skip this for now since it hasn’t been leaving much on the ground. But we did want to tackle …
23May2011
993 CV Boot
Yes, remember they happen in 3. We found a couple of torn boots on Jim’s S2 a few days ago, then we found a torn boot on his 993 when we did his DE inspection. Wonder who the 3rd will be? The patient. And the parts. After removing the heater tube and axle bolts, we jack up the passenger side to allow the angle to drop out the axle. Once out of the car, Jim gets started disassembling the axle. …
23May2011
997 Seat Continued
Finished up the 997 seat frame/motor swap tonight and should have it installed tomorrow. Lots of screws and wires 🙂 Seat back installed and side covers with switches back on. Then lots of wiring running under the seat and installing the various pumps/modules. Almost done. Last thing to do is to install a lower bracket under the seat that holds the front control module. The problem is, the screws insert into the front of the rail, and the seat is …
23May2011
Issues Update
I think we have figured out a solution to our picture issue. Should know by mid week if it pans out. Then I can get the rest of the pictures working again on the older posts.
Ever torn a nice 997 seat apart? Yea, I couldn’t find anyone that had yet, lol. Porsche is doing a lot of repair and warranty repairs on the 997 seat motors which are breaking. The forward/aft drive motor cable breaks and does not drive both sides (well, in fact it only drives one side and not the other, which twists the seat as it goes front to back). Essentially you have a center motor with square cables on each end …
22May2011
911 Finished
Finished up the 911 this weekend after getting the new fuel line and associated parts we needed for the car in. Mmmmm shiny! Pulling the intake manifold up to get the line routed underneath it: And setting back in place. And after a lot of lines, wires, and components, the motor is back together and running. Then it was on to the easier stuff. Starting with a blown headlight bulb. Blown is right. Then we had a problem with the …
22May2011
Temporary Solution
Rigging up a temporary solution for the blog…..at least until we run out of bandwidth. I have my best people working on it….unfortunately, my “people” is out fishing on a boat somewhere in Eastern Washington…….stay tuned.
Hostway has done something to screw up the picture links, so I will probably be down a couple days while I figure this out…..bear with me.
19May2011
911 Carrera Fuel Line Continued
Got some time this afternoon to remove the bad fuel line from the 911 today. Since the line is a giant T shaped line that runs under the center of the intake manifold, that means a lot of stuff has to come off the engine to get the line out. The blower motor assembly, maf, throttle body, and driver’s side of the intake manifold have to come off. AFM and airbox out of the way. And I found a little …
19May2011
944 Clutch Finished And Onto A 911
Got the 944 clutch finished up yesterday and sent it and the gray 911 on their way. Once I got the transaxle put back in and buttoned up the shifter, it was ready for a test drive. Car drove great, another 944 clutch under the belt. With cars leaving, the basic law of the universe states that others must come in to replace them, so on to the next project. This one is a bit of a head shaker for …